Hi guys !!!! are yaou want to make a clone trooper helmet , but you can make it , don't worry i will give the instruction to make clone trooper helmet

Here the instruction , lets check it out !!!

1

Place the empty milk jug upright on your workspace. Take off the top and discard it. Remove the milk label. Place your scissors vertically, with one of the blades pointing down inside the spout. Cut down 6 inches.

2

Cut horizontally around the circumference of the jug 6 inches below the spout. Continue cutting until the top of the milk jug and the spout have been removed. Set that part aside.

3

Flip the milk jug upside down. This will form the base of your helmet. Place the jug over your head and roughly mark where your eyes and nose are with a permanent marker.

4

Place the helmet back on your workspace. Draw a horizontal rectangle around the eye area. Draw a narrow triangle which begins at the bottom of the helmet and ends in a point at the midpoint of the rectangle. Make sure the triangle goes around the nose area that you marked. Cut out the rectangle and triangle.

5

Cut out an 8-inch-by-8-inch piece of black mesh fabric. Glue the mesh on the inside of the helmet with a hot glue gun, covering the nose and mouth holes. Trim excess mesh as needed.

6

Cut a 1-inch-by-7-inch piece of white cardboard. Create a triangle at one end by cutting from one corner inwards at a 45-degree angle. Glue the cardboard to the top of the helmet with the glue gun to create the signature raised crest of a clone trooper helmet.

7

Use a black permanent marker to add details. Try on the helmet and make adjustments as necessary.

That all all of the tutorial to make a clone trooper , thank you , please left a comment